Configuring an ip direct – Clear-Com HX System Frames User Manual
Page 246
Configuring an IP direct
1)
In the Cards and Ports screen, for each of the IVC-32 cards, right click on the
card and select Card Properties.
2)
From the IVC-32 Card Properties screen, enter valid IP addresses and gateways
for the card.
3)
In the Cards and Ports screen, select the direct port.
4)
From the properties list, select IP Port Options.
Figure 10-9 IP Port Options
5)
For the caller IVC-32 card, select the VOIP Caller checkbox. The other card will
be the recipient.
6)
Enter the IP address of the recipient’s IVC-32 card into the caller’s Remote IP
Address so it can make setup the call.
7)
Enter a unique User ID and Password set which matches for caller and recipient
to identify the port it is linking to.
Note:
The following settings can be ignored:
• Local User ID/Password can be ignored for caller
• Remote IP and User ID/Password can be ignored for recipient
Once set up, the IP Direct ports will behave in the same manner as all other Direct ports
As each caller can point to a unique IP address, IP directs on one IVC-32 can link to 32
different destination devices. IP directs cannot link back to a direct on the same card, but
can link to other cards on the same Eclipse matrix.
246
Eclipse EHX Software User Guide