1 description, 2 source, 3 action – Clear-Com HX System Frames User Manual
Page 145: Talk, Description, Source, Action
Figure 5-48 Routes Configuration Screen
After the route has been set up using this screen, it is possible to assign it to a label from
the Control Manager screen. Within the Panel Programming screen and the Stacked Keys
area, with the Control Label programmed onto a panel then double clicking this Label, the
attachments to the Label are displayed.
The following explains each column:
5.49.1
Description
Enter the description of the route into this field. This field is an information field only and is
not used by the Eclipse HX System.
5.49.2
Source
The route Source is the label of the calling Panel/Interface.
5.49.3
Action
The Action field specifies how the route behaves when it is activated. When the mouse
pointer is placed in the action field an arrow is displayed. Right click the arrow to display
the drop-down menu of possible route actions.
Figure 5-49 Route Action Menu
Talk
When this route action is selected the route acts as a talk only route from the source to the
destination. Signalization appears on the destination.
145
Eclipse EHX Software User Guide