Filter, Output area, Filter settings – Clear-Com HX System Frames User Manual
Page 225
Filter
The filter column shows a graphic representing the type of audio filtering that is being
applied to the audio inputs. The graphic represents the frequency profile of the input filters.
Output area
The top row of the output area lists all the outputs that may be available in the
configuration. All of the possible outputs are listed below but some outputs may not be
available in specific configurations.
Main LS
This outputs audio to the main panel loudspeaker.
Aux o/p
This outputs audio to the auxiliary loudspeaker via the auxiliary audio connector.
Matrix1
This output sends either mono audio to the matrix via the analogue matrix connection or
one channel of stereo audio to the matrix via the AES3 digital connection.
Matrix2
This output sends one channel of stereo audio to the matrix via the AES3 digital matrix
connection. This output is only available if the AES3 digital option card is fitted.
HS1L
This output sends audio to the main panel headset left ear.
HS1R
This output sends audio to the main panel headset right ear.
HS2L
This output sends audio to the second headset left ear via the auxiliary audio connector.
HS2R
This output sends audio to the second headset right ear via the auxiliary audio connector.
Ext1
This sends audio output to the first external output via the auxiliary audio connector.
Ext2
This sends audio output to the second external output via the auxiliary audio connector.
Hot Mic
This sends audio output to the hot mic output via the auxiliary audio connector.
Voicerec
This output sends audio to the Listen Again voice recording facility.
Filter settings
The filters are applied to input audio streams to remove extraneous noise from the audio
before it is sent to the mixer. There are two types of filter; the Low Pass filter and the High
Pass filter.
225
Eclipse EHX Software User Guide