2 cable length, 3 description, 4 engineer comments – Clear-Com HX System Frames User Manual
Page 116: 5 listen label, 6 talk label, 36 splitter connections, Cable length, Description, Engineer comments, Listen label
5.35.2
Cable length
1)
To set the cable length between the card and the antenna select the Cable
Length option and open the drop-down slider. Adjust the cable length setting from
0 - 129 meters to 2860 - 2989 meters.
The length set is displayed next to the option.
5.35.3
Description
Enter an optional description for the antenna such as position or function.
5.35.4
Engineer comments
A scratchpad for engineers to record any relevant information about the port or antenna.
5.35.5
Listen label
Listen labels for antennas are only used for diagnostics purposes, such as antenna/role
correlation (a combined Talk/Listen label is shown unless the option for 10 character labels
is turned off).
5.35.6
Talk label
Talk labels for antennas are only used for diagnostics purposes such as antenna/role
correlation (a combined Talk/Listen label is shown unless the option for 10 character labels
is turned off).
5.36
Splitter connections
Figure 5-24 E-QUE Splitter Configuration
1)
Select the card port to be configured and go to Port Properties > Beltpack
Antenna > Basic Options to set up the port parameters.
116
Eclipse EHX Software User Guide