Gooseneck mic type, Panel text orientation, Line release – Clear-Com HX System Frames User Manual
Page 88: Screen saver timer, Applies to
Page override allowed
The panel main volume audio can be overridden by paging audio from another panel. The
default setting is disabled. For Page Override to operate this must be set to True on any
destination panel where the local main volume setting may need to be overridden by a
calling panel. This is used in conjunction with Page Volume.
Note:
Only available on Concert, V-Series panels.
Page gain
Allows the Page Override gain to be set.
1)
Use the gain adjust slider to set the required level. The level range is from 0 to
10dB. The default volume setting is 0dB.
This is used in conjunction with Page Override.
Note:
Only available on Concert, V-Series and I-Series Panels.
Gooseneck mic type
The Gooseneck Mic Type allows the type of panel microphone to be configured.
1)
To set the microphone type highlight the item to allow the drop-down menu to be
displayed. The options for microphones are Dynamic Balanced, Dynamic
Unbalanced and Electret (default).
Panel text orientation
Determines the orientation of label text on V-series panels.
Line release
Allows the panel to release the selected telephone line which may be held on by the
incoming caller anywhere in the system. The default is disabled.
Note:
Not available on Concert.
Screen saver timer
The screen saver timer facility sets the length of time a panel is inactive elapse before the
screen saver is displayed. The screen saver is used to prevent the display being damaged
by being left for long periods with the same display. The time may be set to any value
between 1 and 60 minutes. It cannot be disabled.
If the dim timer is set to a value other than Always Dim the screen saver timer only starts
after the screen has dimmed. For example if the dim timer is set to 1 minute and the
screen saver timer is set to 1 minute the screen saver starts after 2 minutes. If the dim
timer is set to Always Dim the screen saver inactivity timer starts immediately.
Note:
Only available on V-Series Panels.
Applies to:
All panel devices.
88
Eclipse EHX Software User Guide