Clear-Com HX System Frames - Manual (Page 274)

Figure 13-10 Request Info Button
6) Choose Change IP Address from the list in the left hand pane and enter the
desired values listed below.
Figure 13-11 IP Address Entry
• Select parameter 1 and enter the pin code.
• Select parameter 2 and enter interface 1 and then enter the LAN1 port
address.
• Select parameter 2 and enter interface 2 and then enter the LAN2 port address
(Omega, Median and Delta matrix only).
• Select parameter 3 and enter the subnet mask.
• Select parameter 4 and enter the default gateway address
7) Click on Send to update the matrix.
8) A message from the Matrix indicating that the change was successful is seen in
the log, and the matrix resets.
9) Close Matrix Event Log, and open My Systems.
10) Change the IP address in My Systems to be the same as the new value in the
matrix.
11) Press Save and Activate.
12) Note that it may be necessary to change the IP address and subnet mask of the
PC if the new matrix IP address is from a different network range.
274 Eclipse EHX Software User Guide