2 serial connection, Serial connection – Clear-Com HX System Frames User Manual
Page 39
4)
Select Internet Protocol Version 4, and then select Properties. The following
screen appears:
Figure 3-8 Internet Protocol Version 4
5)
Select Use the following IP address, and then enter the correct IP address
(169.254.0.10) and Subnet mask (255.255.0.0), and then click OK.
3.3.2
Serial connection
To establish a serial connection between the EHX PC and the matrix the hardware must
be connected first and then the software configured.
To establish the hardware connection, connect a serial (RS-232) cable between the
computer's serial port and the connector labelled RS-232 on the rear of the Eclipse HX
matrix.
39
Eclipse EHX Software User Guide
This manual is related to the following products: