One digit code setup – Clear-Com HX System Frames User Manual
Page 156
One digit code setup
To assign the one-digit selector codes (numbered 0 through 9), set the [One Digit Codes]
field in the Advanced Settings screen for a telephone interface to true.
1)
From the telephones Advanced Setting screen select Assign DTMF Codes to
open the DTMF Assignment screen.
Figure 5-55 Single Digit DTMF Assignments
2)
Select the desired destination label from the palette of available destinations, at
the bottom of the screen.
3)
Find the desired code in the DTMF Codes column.
4)
The columns to the right of the DTMF Codes column allow assigning as many as
three talk labels and one listen label for each key. Click in the column for the
desired type of label for the desired code: Talk 1, Talk 2, Talk 3, or Listen. The
selected label appears in the desired cell. If this cell has already been assigned a
label, the new label displaces the old one.
5)
Download the new configuration to the matrix with an Apply Label Changes
download.
Note:
When a user manual dials, the DTMF tones go out on the last selected talk to an interface
(in ECS v5.2.4, the DTMF tones go out on the last TEL-14 port). An interface is either a
TEL-14, CCI-22, FOR-22 or a Direct.
156
Eclipse EHX Software User Guide