1 port function, 2 label, 3 description – Clear-Com HX System Frames User Manual
Page 114: 33 e-que splitter, Port function, Label, Description, E-que splitter
Figure 5-21 Antenna Ports
5.32.1
Port function
This is always set to Antenna.
5.32.2
Label
Label for the port used to assign the port to a path. The label has 10 characters, or can be
split into two parts, each of maximum five characters.
5.32.3
Description
An optional description for the port of up to 255 characters long.
5.33
E-QUE splitter
This action automatically adds an E-Que card with two splitter ports configured. Each
splitter can support up to five antennae and each antenna provides six beltpack ports. The
hardware table shows ten antennae with the first beltpack port number for each antenna
rather than the E-QUE port number.
Therefore the first antenna is shown as port 1 (the first beltpack port) and the second
antenna is shown as port 7 (previous first port number plus six), since beltpack ports 1-6
are on the first antenna. This is repeated for successive antennae.
Figure 5-22 Splitter Ports
5.33.1
Port function
This is always set to Antenna.
114
Eclipse EHX Software User Guide