Rainbow Electronics DS3170 - Manual (Page 197)

DS3170 DS3/E3 Single-Chip Transceiver
197 of 233
Register Name: E3G832.RSRL1
Register Description: E3 G.832 Receive Status Register Latched #1
Register Address: 128h
Bit
# 15 14 13 12 11 10 9 8
Name Reserved -- TIL RPTUL RPTML RPTL Reserved RUA1L
Bit
# 7 6 5 4 3 2 1 0
Name GCL NRL COFAL LOFL RDIL AISL OOFL LOSL
Bit 13: Timing Source Indication Change Latched (TIL) – This bit is set when the TI[3:0] bits change state.
Bit 12: Receive Payload Type Unstable Latched (RPTUL) – This bit is set when the RPTU bit transitions from
zero to one.
Bit 11: Receive Payload Type Mismatch Latched (RPTML) – This bit is set when the RPTM bit transitions from
zero to one.
Bit 10: Receive Payload Type Change Latched (RPTL) – This bit is set when the RPT[2:0] bits change state.
Bit 8: Receive Unframed All 1’s Change Latched (RUA1L) – This bit is set when the RUA1 bit changes state.
Bit 7: GC Byte Change Latched (GCL) – This bit is set when the RGC byte changes state.
Bit 6: NR Byte Change Latched (NRL) – This bit is set when the RNR byte changes state.
Bit 5: Change Of Frame Alignment Latched (COFAL) – This bit is set when the data path frame counters are
updated with a new frame alignment that is different from the previous frame alignment.
Bit 4: Loss Of Frame Change Latched (LOFL) – This bit is set when the LOF bit changes state.
Bit 3: Remote Defect Indication Change Latched (RDIL) – This bit is set when the RDI bit changes state.
Bit 2: Alarm Indication Signal Change Latched (AISL) – This bit is set when the AIS bit changes state.
Bit 1: Out Of Frame Change Latched (OOFL) – This bit is set when the OOF bit changes state.
Bit 0: Loss Of Signal Change Latched (LOSL) – This bit is set when the LOS bit changes state.
Register Name:
E3G832.RSRL2
Register Description: E3 G.832 Receive Status Register Latched #2
Register Address: 12Ah
Bit
# 15 14 13 12 11 10 9 8
Name -- -- -- -- Reserved FBEL PEL FEL
Bit
# 7 6 5 4 3 2 1 0
Name -- -- -- -- Reserved FBECL PECL FECL
Bit 10: Remote Error Indication Latched (FBEL) – This bit is set when a remote error indication is detected.
Bit 9: Parity Error Latched (PEL) – This bit is set when a BIP-8 parity error is detected.
Bit 8: Framing Error Latched (FEL) – This bit is set when a framing error is detected.
Bit 2: Remote Error Indication Count Latched (FBECL) – This bit is set when the FBEC bit transitions from zero
to one.
Bit 1: Parity Error Count Latched (PECL) – This bit is set when the PEC bit transitions from zero to one.
Bit 0: Framing Error Count Latched (FECL) – This bit is set when the FEC bit transitions from zero to one.