EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 99)

EVS Multicam - User Manual Version 9.00
EVS Broadcast Equipment SA – March 2008
90
To search for clips or trains containing a specific TC, proceed as follows:
1. From the main Remote screen in Clip mode or Train mode, press
MENU to access the secondary menu.
2. Press SHIFT+C to access the Sort TC function.
The following screen is displayed:
Sort TC xx:xx:xx:xx
[Menu] : Cancel
[Enter] : Search
Reset Set TC From Date To Date
Return Clip LTC Srch Net
3. If requested, press SHIFT+C to define a date from which the search
should be applied:
1. Type the date in dd/mm/yy format with the F1 to F10 keys.
2. Press ENTER to confirm and exit the field.
4. If requested, press SHIFT+D to define a date to which the search
should be applied:
1. Type the date in dd/mm/yy format with the F1 to F10 keys.
2. Press ENTER to confirm and exit the field.
5. Press the B key to specify whether to search for clips (Clip), train
(Rec) or both (Clip+Rec).
Press several times the B key to select the requested value.
6. Press the C key to specify whether to search for the LTC (LTC), the
user-defined time code type (USER) or whatever TC type
(LTC+USER).
Press several times the C soft key to select the requested value.
7. Press the D key to specify whether to search only for local clips (Srch
Loc) or on the entire XNet Network (Srch Net).
Press several times the D key to select the requested value.
8. Press ENTER to launch the search.
Results
If matching clips are found, the Remote panel will automatically be in
Browse mode (the BROWSE key is red), allowing the operator to quickly
view the frame of each clip corresponding to the requested time code by
rotating the jog dial.
To be able to jog inside a clip, disable the Browse mode by pressing on the
BROWSE key and move the jog dial. To return to the Browse mode inside
the search results, press the BROWSE key again.
Search results are reset when going by to LIVE mode, or when a new search
is performed.