2 confirm delete clip, 3 auto name clips, 4 clip post-roll – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 29

EVS
Multicam - User Manual
Version 9.00
EVS Broadcast Equipment SA – March 2008
20
4.7.2
C
ONFIRM
D
ELETE
C
LIP
Possible values: No (default) / Yes
No: clips are deleted immediately
Yes: a confirmation is required when deleting clips, either from the Remote
or from the keyboard.
Note
This parameter does not apply to the Clear All Clips command
(Main menu) which already has its own confirmation message.
4.7.3
A
UTO
N
AME
C
LIPS
Possible values: Disabled (default) / TC IN / CAM Name / ID Louth / VAR ID
If this function is enabled, the value of the selected field will automatically
be used to name the clip upon creation.
The values from the following fields can be used to automatically name
clips:
Value Meaning
Disabled
(Default)
No name is assigned to a clip when it is created.
TC IN
The time code of the IN point of the clip is automatically
assigned to a clip when it is created.
CAM Name
The name of the recorder channel is automatically
assigned to a clip when it is created.
ID Louth
The ID Louth of the clip, i.e. the unique identifier for the
clip on the XNet network, is assigned to a clip when it is
created.
VAR ID
The VAR ID of the clip is assigned to a clip when it is
created.
When this option is selected, the VAR ID used to assign a
name to the clip will be limited to the first 8 characters of
this field.
4.7.4
C
LIP
P
OST
-R
OLL
Possible range: 00s00fr to 30s00fr. Default: 02s00fr.
When the Post-Roll function is enabled from the secondary clip menu, the
clip will play through its OUT point for a duration defined by the Post-Roll
parameter. This is also valid inside record trains if the Record Train OUTs
parameter is set to “Freeze”.