How to return to the main menu, Function keys in the main menu, Main menu – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 18

EVS
Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
9
3. Main Menu
After the boot sequence of the Multicam system, the LCD screen of the
Remote Control panel will display the Main menu:
Note
If 2 channels are available for the 1
s t
Remote, the B key will
display 2 PGM. If 3 channels are available, the B key will display 3
PGM.
The Main menu has special function key operations as shown above, as well
as the “soft” keys options to enter 1PGM, 1PGM+PRV, 2PGM, or 3PGM
modes (if available) and to enter the Setup menu to configure your remote
controller or to add special functions to your application.
H
OW TO
R
ETURN TO THE
M
AIN
M
ENU
From any section of the application, except Playlist mode, press SHIFT +
MENU on the first Remote Control panel to return to the Main menu.
F
UNCTION
K
EYS IN THE
M
AIN
M
ENU
Select the corresponding Function key (F_ key), and then press ENTER to
validate the selection.
Function Key
Use
F1 to F4
If desired, the Multicam system can be run using 1, 2,
3 or 4 EVS Remote panels. Depending on the number
of play channels available in the current configuration,
1-, 2-, 3- or 4- Remote modes will be available from
the Main menu.
F1: 1 Remote
One Remote panel is used in the configuration
F2: 2 Remotes
Two Remote panels are used in the configuration.
If 4 play channels are available, when selecting the 2
Remotes mode, the operator can chose between 2
2Rec 4Play
XT Multi-Cam
Ver:09.00.xx
F1:
1 Remote
F6: Exit
F2: 2 Remotes
F7: Clear all clips
F3: 3 Remotes
F8: Stop Record
F4: 4 Remotes
F9: Fill Playlist
F5: Char. On/Off F0: Save Clips+Plist
Split
Paint
Target
Setup
1PGM+PRV
3
PGM