10 how to restripe the time code of a clip, 10 h, Ow to – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 95: Estripe the, Ode of a

EVS
Multicam - User Manual
Version 9.00
EVS Broadcast Equipment SA – March 2008
86
11.2.10
H
OW TO
R
ESTRIPE THE
T
IME
C
ODE OF A
C
LIP
The function to restripe the time code of a clip via the Remote panel is more
restricted than via Multicam on the VGA:
• You cannot choose which time code type you modify: you will
automatically modify the primary time code of the clip.
• You cannot modify the date of the clip.
• You cannot modify the type for the primary time code of the clip.
If you want to modify the date, the type of the primary time code or the
user-defined time code, you need to go to the Set Time Code screen in the
VGA. For more information, refer to the section 11.3.9.4 “How to Restripe
the Time code of the Current Clip”, on page 102.
To restripe the time code of a clip on the Remote panel, proceed as follows:
1.
Recall the clip by pressing the corresponding F_ key.
2.
Move the jog dial to reach the picture where you want to define a new
time code.
3.
Press the MENU key to access the secondary menu.
4.
Press SHIFT+C to call the Set TC function.
5.
Enter the new time code for the current picture.
6.
In 59.94Hz modes (NTSC), you can select between Drop Frame and
Non Drop Frame modes by pressing SHIFT+MENU.
7.
Press the D key to select CAM or CLIP mode.
• In CAM mode, only the time code of the camera angle loaded on
the primary channel will be changed.
• In CLIP mode, the time code of all camera angles of the clip will
be changed.
8.
Press ENTER to confirm or MENU to cancel.
The primary time code of the entire clip is updated according to the new
time code value so that the time code remains continuous inside the whole
clip. The next time this function is called the value previously used will be
set as default.