10 pre-roll, 11 record train outs, 12 freeze on cue points – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 26: 10 p, 11 r, 12 f

EVS
Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
17
4.6.10
P
RE
-R
OLL
Range: from 0s01fr to 5s00fr. Default: 0s05fr
Pre-roll duration used when recalling a cue point.
4.6.11
R
ECORD
T
RAIN
OUT
S
Possible values: Play through (default) / Freeze
When this parameter is set to “Freeze”, and an OUT point is marked in a
record train, Multicam will countdown to the OUT point and automatically
freeze on that picture (if the Post-Roll mode is disabled) or on that picture +
the Post-Roll duration (if the Post-Roll mode is enabled) when replaying
that section.
When the parameter is set to “Play through”, Multicam will still countdown to
the OUT point, but will keep playing through this point. In a clip, Multicam
always freezes on the OUT point (or OUT point + Post-Roll duration when
Post-Roll mode is enabled).
4.6.12
F
REEZE ON
C
UE
P
OINTS
Possible values: No (default) / Yes
The purpose of this functionality is to allow marking cue points on any field
of a record train and freeze on the cue point when the playback reaches it.
This is similar to the freeze on OUT point functionality but because it will be
done on cue point, you will be able to freeze on any field (impossible with
OUT points).
When playing record trains where cue points have been marked, the playout
freezes on the cue point if the parameter is set to “Yes”. It plays through if
the parameter is set to “No”.
The Post-Roll parameter is not taken into account for this functionality.