5 the function bar, F1: name, How to name a clip – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 104: F2: clip/cam, Unction

EVS
Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
95
11.3.5
T
HE
F
UNCTION
B
AR
The second line displays the available functions. Each function can be
called by the corresponding F_ key of the keyboard, or by clicking with
stylus & tablet on the corresponding area on this line.
F1:
N
AME
This function is used to name a clip.
How to Name a Clip
1.
In the Clip screen, select the clip to name in one of the following
ways:
• Click on the clip with the stylus
• Positioning the green arrows around the desired clip with the
keyboard.
2.
Type in the desired name with the keyboard. All characters available
from the keyboard are accepted, including blanks.
3.
Press F1:
• In CAM mode, only the camera where the cursor is located is
named.
• In CLIP mode, all cameras of the clip where the cursor is located
are named.
The entry in the Name field is not cleared by pressing F1 and remains for
future use. Press <BACKSPACE> to delete the last character in the Name
field, or press ESC to clear the whole field.
Note
To be able to name/rename clips on a network machine, the Clip
Edit by Network setting in the setup of the remote machine must
be set to “Yes” (VGA Setup screen) or “Enabled” (Setup menu on
the Remote panel). If you are unable to name a network clip,
please check this setting on the remote machine.
F2:
C
LIP
/C
AM
This function toggles between CLIP mode and CAM mode.
• In CLIP mode, actions on a clip will use all available cameras for this
clip.
• In CAM mode, actions on a clip will only use the selected camera for
this clip.
Other functions such as Name, Delete, Copy, Set TC, >Archive depend on
this mode’s selection.