Return, 2 selection of clip banks and playlists, Page – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 70

EVS
Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
61
RETURN
Inside a clip, press the RETURN key to remain on the same picture, but
inside the record train instead of the clip (if that picture still exists in the
record train). This is useful when a clip is too tight and you want to use
material beyond the current IN or OUT point.
PAGE
Use this key to select a new clips page. After pressing the PAGE key, you
must press a F_ key to select the corresponding page (1 to 10).
6.2
SELECTION OF CLIP BANKS AND
PLAYLISTS
SHIFT + F1 - F9
=
CLIPS BANK
This allows access to clip banks 1 through 9 within the clip page (1 to 10).
SHIFT + F1
=
BANK 1
SHIFT + F2
=
BANK 2, etc. (up to bank 9)
Once in the bank, selection of the F1 – F10 keys will call up the respective
clips. If Recall Clip Toggle is enabled in the Setup menu, pressing several
times on the same F_ key will call successively all camera angles of that
clip.
The clip numbering system is as follows:
Example: Clip 547 where
• “5” refers to the clip page number (1 to 10).
• “4” refers to the clip bank (1 to 9)
• “7” refers to the clip number (1 to 10) inside the bank
Note
To identify remote clips when using the XNet SDTI network, the
number of the clip is followed by the number of the machine on
the network. i.e. Clip 547B/04
SHIFT + F10 =
playlist BANK
This combination of keys gives access to the playlists’ banks. Within each
clip page there are 10 playlists. Selecting F1-F10 at this point calls up the
corresponding playlist.
Example: Playlist 51 where