Setup menu, 1 how to access the setup menu, 2 how to navigate in the setup menu – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 20

EVS
Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
11
4. Setup Menu
Important
Prior to using Multicam, the operator should enter the Setup menu
and set all necessary parameters. If clips are stored with certain
parameters and the operator wishes to change them afterwards,
those clips and playlists will not change. It is thus important to set
these parameters first.
The Setup menu allows the operator to define parameters regarding some
functions. The new parameters are saved as soon as they are modified.
4.1
HOW TO ACCESS THE SETUP MENU
To access the Setup menu, proceed as follows:
1.
If you are in Playlist mode, press RECORD first to exit this mode.
2.
Press SHIFT + MENU key to go to the Main menu:
Split
Paint
Target
Setup
1PGM+PRV 2/3
PGM
3.
Select Setup by pressing SHIFT + D to enter the Setup menu.
The Setup menu is divided in sections (clips, playlists, special
effects, audio, control, GPI, etc.) When entering the setup, a menu
presents these sections.
4.
To access a section, press the corresponding F_ key.
4.2
HOW TO NAVIGATE IN THE SETUP
MENU
The navigation within the Setup menu follows the following principles:
• To move to the previous/next page inside a section, use F9 and F10.
• To more directly to another section when you are inside a section, press
SHIFT + F_ key corresponding to the section to access.
• To move from a section to the next one, press F10 when you reach the
last page of a section. You will access the first page of the next section.
By starting on the first page and pressing F10, the operator goes