7 how to copy / move a clip from the remote panel, 1 settings on copy/move clips, Clip mode/cam mode – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 92: Ow to, Ove a, Rom the, Emote panel

EVS
Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
83
11.2.7
H
OW TO
C
OPY
/
M
OVE A
C
LIP
F
ROM THE
R
EMOTE
PANEL
It is possible to copy or move a clip on the same XT[2] server or to another
XT[2] server. “Record in progress” clips can also be copied and moved.
To copy or move a clip from the Remote panel, proceed as follows:
1.
Select the original clip.
2.
Select an empty location on the same machine.
3.
A new menu appears on the LCD display of the Remote panel, with
the corresponding message on the OSD of the output monitors:
4.
Select the COPY or MOVE function by pressing the A or B key.
The corresponding function will be highlighted on the LCD and the
message on the OSD will be updated accordingly.
5.
Select the CLIP or CAM mode with the D key.
See Section “Settings on Copy/Move Clips” below.
6.
In case of network copy, select the SHORT or LONG mode with the C
key.
See Section “Settings on Copy/Move Clips” below.
7.
Press ENTER to confirm or MENU to cancel.
When doing a network copy, the VGA displays the % copied of each clip.
11.2.7.1
S
ETTINGS ON
C
OPY
/M
OVE
C
LIPS
When you copy/move a clip, two settings are available to specify how the
clip should be copied or moved:
Clip Mode/Cam Mode
Pressing the D key in the Copy/Move LCD window allows the user to select
a value for this setting:
• CLIP mode: all camera angles of the clips will be copied/moved.
• CAM mode: only the camera angles of the clip loaded on the controlled
channels will be copied/moved.
Copy Clip 113 to Clip 141
Cam A B
[Menu]: Cancel
[Enter]: Confirm
C O P Y
M O V E
S H O R T
C L I P