beautypg.com

1 main controller for pgm1, 2 main controller for pgm2/3/4, 13 special control settings – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual

Page 46: Pgm1, Pgm2/3/4, Ontroller for

background image

EVS

Multicam - User Manual

EVS Broadcast Equipment SA – March 2008

Version 9.00

37

4.13

SPECIAL CONTROL SETTINGS

Special Control Settings p.7.2

Main RS422 Second. RS422

PGM1: EVS Remote -- [F5]Sony BVW75 04

PGM2:[F2]EVS Remote –- [F6]Sony BVW75 05

PGM3:[F3]EVS Remote –- [F7]---------- --

PGM4:[F4]EVS Remote –- [F8]---------- --

[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn

This page is used to define which device/controller can control which PGM
channel. For each PGM channel, you must define the main controller,
selecting from the list defined on page 7.1.

• In LSM mode, the main controller for PGM1 must always be an EVS

remote. This can not be changed by the operator.

• If the main controller is an EVS Remote, the RS422 port will be

automatically assigned and is not specified by the operator.

• If the main controller is an EVS remote, it is then possible to specify a

secondary controller for that channel, that can be a protocol defined on
page 7.1. The EVS remote controlling that channel can then decide at
any time to pass the control to, or to retrieve the control from the
secondary controller.

• Like for page 7.1, all EVS remotes must be the first in the list of Main

controllers, without gap. It is not allowed to have a protocol preceding
an EVS remote in this list.

• A protocol (other than EVS AVSP or EVS IPDP protocols) can only be

assigned to 1 channel at a time.

• EVS AVSP and IPDP protocols can be assigned to several channel

simultaneously. If you need to assign some channels to an AirBox, you
must set the main controller for these channels to EVS AVSP. If you
need to assign some channels to an IP Director, you must set the main
controller for these channels to EVS IPDP.

4.13.1

M

AIN

C

ONTROLLER FOR

PGM1

Possible values: EVS Remote

When working in LSM base configuration, the PGM1 main controller must
always be an EVS Remote. No other possible selection

4.13.2

M

AIN

C

ONTROLLER FOR

PGM2/3/4

Possible values: EVS Remote (default) + list of protocols-RS422 ports