EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 68)

EVS Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
59
To go to a given time code, proceed as follows:
1. Press SHIFT+GOTO TC key on the Remote.
The GOTO TC window is displayed on the Remote panel :
Go to TC xx:xx:xx:xx
[Menu] : Cancel
[Enter] : Go to TC
Reset From Date To Date
Return LTC
2. To specify a date from which the search should be executed, press
SHIFT+C, enter the date in the following format dd/mm/yy using the
F1 to F10 keys and press ENTER on the Remote.
3. To specify a date up to which the search should be executed, press
SHIFT+D and enter the date in the following format dd/mm/yy using
the F1 to F10 keys and press ENTER on the Remote.
4. To specify whether to go to a LTC, USER time code or any of both
(LTC/USER), press C until the requested time code type is displayed.
5. Enter the requested time code using the function keys F1 to F10.
Eight digits: hh:mm:ss;ff (f=frame) are displayed on the LCD screen
of the Remote.
• If you enter all 8 digits, Multicam will automatically go to the
required time code.
• If you enter less than 8 digits (when the last digits are zeros),
press ENTER on the Remote to validate the entry and reach the
requested time code.
Once you have entered the Goto TC, you can observe it has been
correctly entered on the display of the Remote LCD screen and on the
output monitor. This Time code display appears in the centre of the
LCD display, just above the menu options.
6. Press ENTER on the Remote.
If the time code is from the LTC table, it will be displayed in white on the
output monitor.
If the time code is from the USER TC table, it will be displayed in yellow
output monitor.
If nothing happens after confirming the TC entry with ENTER, this means
that the field corresponding to the selected Time code does not exist on
disk any longer.