EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 119)

EVS Multicam - User Manual Version 9.00
EVS Broadcast Equipment SA – March 2008
110
11.4.4 VDR P
ANEL
– R
ECORDER
WINDOW
The VDR Panel Recorder can be used to start/stop the record, and to create
clips from the local record trains. For example, it allows the creation of
clips on a server that has no Play channel.
11.4.4.1 H
OW TO
S
TART
/S
TOP THE
R
ECORD
Press ALT+R to start or stop the record on the record channel assigned to
the window. No confirmation is required.
Important
In LSM mode, all recorders will be stopped at once to keep the
synchronization between all record channels.
11.4.4.2 C
REATING
C
LIPS WITH THE
VDR P
ANEL
R
ECORDER
1. Press ALT+I / ALT+O to mark a Short IN / Short OUT point on the last
recorded picture. The time code appears in the adjacent field, and the
cursor is automatically placed on that field to allow the operator to edit
the time code of the Short IN / Short OUT point if desired. Press ENTER
to confirm or ESC to cancel.
2. Repeat this operation for the complementary Short IN / OUT point. This
is not mandatory. If only a Short IN or a Short OUT point is marked, the
Default Clip Duration defined in the Setup (p.2.2 F2) will be used to
define the missing point.
3. Select from which record train(s) the clip(s) must be created: press ALT
+ the letter (A/B/C/D/E/F) of a record train to select / de-select it.
Letters highlighted in RED means that a clip will be created from the
corresponding record train ; letters highlighted in green means that the
corresponding record train is available but will not be used to create a
clip.