beautypg.com

5 deleting swap points, 6 navigating swap points, 1 introduction – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual

Page 164: 4 replace function

background image

EVS

Multicam - User Manual

EVS Broadcast Equipment SA – March 2008

Version 9.00

155

Note

Selecting track 0 will mute the output until the next swap point
or the end of the clip.

Several swap points can be set on the same time code (e.g.: 1 -> 3, 2 -> 4).

13.3.5

D

ELETING

S

WAP

P

OINTS

When the operator is on a swap point, pressing CLEAR + IN/OUT deletes
the current swap point. All swap points for that time code are deleted.

When the operator is not on a swap point, pressing CLEAR + IN/OUT brings
up a confirmation message to delete all swap points for the current clip.

13.3.6

N

AVIGATING

S

WAP

P

OINTS

When the operator is in Swap mode, the previous swap point can be
reached by pressing the Go to In button on the Remote. The next swap
point is reached by pressing the Go to Out button. The function works in
loop mode.

13.4

REPLACE FUNCTION

13.4.1

I

NTRODUCTION

The purpose of the Replace function is to automate a routine used by
operators to create effects in a playlist: the operator would loop a section or
an entire playlist back to themselves and, during the playback, add some
effects externally (graphic insertion for instance) or internally (changing the
speed).

The operator would then edit the original playlist to insert the desired
section into the original playlist. That section would need to be inserted in
the playlist by matching the IN/OUT frames on the original playlist to the
new clip created with the re-recorded material.

The Replace function automates this process.

Note

The Replace function is not allowed on playlists containing
“record in progress” clips.