B/02, 8 mapping network cameras – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 180

EVS
Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
171
3. Press the RECORD key to select the LIVE mode.
A 2 to 3-second delay to LIVE has been defined to ensure safe
operations.
4. Use the JOG key to go in search mode.
5. Change camera angles if necessary. The changing camera angles on
network train will always switch in pause on the new camera.
Refer to the note below about the remote camera name.
6. Press the IN key to mark your Short IN point of the clip.
7. Search the Short OUT point and press the OUT key to mark it.
8. Select the clip location to store and press the corresponding F_ key.
Note
The label of the remote camera is different in order to identify it
easily
Remote LSM
B/02
Camera
CAM
Note
The key flashes during transfer. When the key lights green, the
transfer is completed and the clip is available for playback from
the local system.
14.8
MAPPING NETWORK CAMERAS
Note
Mapping network cameras is a software option
It is possible to map network cameras to unused camera position on the
Remote up to the D camera. For instance, if the configuration is 2IN 2OUT,
it is possible to map 2 network cameras.
The mapping allows a quick selection of network trains on the network.
Those cameras are NOT recorded on the local server, they remain recorded
on the destination server.