beautypg.com

Examples, 1 set tc, 2 name – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual

Page 100: 3 search, 4 post-roll, 5 clip/cam

background image

EVS

Multicam - User Manual

EVS Broadcast Equipment SA – March 2008

Version 9.00

91

Examples

• You have loaded the picture of an interesting event, and you want to see

all clips that contain that same event. Call the Sort ->TC function, select
the network/local search option and launch the search. Move the jog dial
and you will see the same event on the same time code from all
available camera angles that have been clipped.

• You know the time code of a particular event and you want to see all

clips containing that event. Call the Sort ->TC function, edit the time
code to the desired value, select the network/local search option and
press ENTER: you will obtain the same result as above if the time code
belongs to the same type as the one previously mentioned.

11.2.11.1 S

ET

TC

The Set TC function is only available in SHIFT+B on the Sort->TC menu. It
allows the operator to restripe the time code of a clip. This function is
explained in details in the Section 11.3.9.4 “How to Restripe the Time code
of the Current Clip”
, on page 102.

Depending on the mode selected with the D key (CLIP/CAM), the new time
code value is assigned only to the camera angle of the clip loaded on the
primary channel (CAM mode), or to all camera angles of the clip (CLIP
mode).

11.2.11.2 N

AME

The Name function is only available if a keyword file is selected in the
Setup menu. It is used to name a clip based on available keywords. Refer to
the Chapter 12 “Keyword Management”, on page 112 for more details. When
the Name function is selected, pressing SHIFT+C again will call the Search
function.

11.2.11.3 S

EARCH

The Search function is “hidden” behind the Name function. Press SHIFT+C
again in Name mode to call it. It allows the operator to search the database
for clips based on keywords and ranking. Please refer to Chapter 12
Keyword Management”, on page 112 for details.

11.2.11.4 P

OST

-R

OLL

This function enables/disables the Post-Roll mode. This mode is explained
in details in the section PostRoll, on page 68.

11.2.11.5 C

LIP

/C

AM

Pressing the D key will toggle between CAM and CLIP modes on the remote.