EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 21)

EVS Multicam - User Manual Version 9.00
EVS Broadcast Equipment SA – March 2008
12
through all pages: p.1.1 Æ p.2.1 Æ p.2.2 Æ…
• To move from a section to the former one, press F9 when you reach the
first page of a section. You will access the last page of the previous
section.
• To leave a section and go back to the main page of the Setup menu (see
screenshot below), press the MENU key.
LSM Setup Menu Main page
[F1]OSD Settings [F6]EVS Controller
[F2]Record Trains [F7]RS422 Control
[F3]Clips [F8]GPI
[F4]Playlist [F9]Special Effects
[F5]Audio Clr+[F0]Restore Defaults
[Menu]Quit [Clr+F_]Default [F0]PgDn
• To exit the Setup menu when you are in the main page of the Setup
menu, press the MENU key.
4.3 HOW TO SELECT AND TO MODIFY
PARAMETERS
To modify the parameters, you can proceed as follows for most of the
parameters:
1. Go to the desired page as explained in the Section 4.2.
2. Select the parameter to be modified by pressing the corresponding F_
key.
3. Make adjustment by rotating the jog dial.
4. Press the corresponding F_ key again to validate the modification.
5. Press MENU to return to the main page of the Setup menu.
4.4 HOW TO RESET THE DEFAULT
VALUES
To restore the default value of a parameter in the Setup menu, proceed as
follows:
1. Go to the desired page as explained in the Section 4.2.
2. Press CLEAR and the F_ key that corresponds to the parameter on
which to restore the default values. Confirm the action.
To restore the default values on the entire Setup menu, press CLEAR + F0
and confirm the action.