EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 184)

EVS Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
175
14.9.2 H
OW TO
D
ISCONNECT A
M
ACHINE FROM THE
S
ERVER
The operator has the possibility to disconnect a machine from the XNet
Network. This can be useful when setting up an SDTI network or
troubleshooting an SDTI network issue.
To disconnect a machine from the server, proceed as follows:
1. Press SHIFT-F4 to access the SDTI Network Monitoring screen.
2. Press CTRL-ALT-L to disconnect the XHub branch from the network.
The following warning is displayed:
Warning
The network branch you are connected on will be
disconnected from the network.
All network actions will be disabled.
ESC: Cancel ENTER: Confirm
3. Press ENTER to confirm that you want to disconnect the XHub branch
from the network.
On the SDTI Network Monitoring screen, the following message in red font
informs that the machine is disconnected and how it can be connected
again:
“XHub branch disconnected from the network. Press
CTRL-ALT-L to reconnect.”