beautypg.com

In/o – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual

Page 178

background image

EVS

Multicam - User Manual

EVS Broadcast Equipment SA – March 2008

Version 9.00

169

14.7.2

H

OW TO

N

AME A

R

EMOTE

C

LIP

1. Select the Clip mode in the Network menu.

2. Select the Remote LSM in the list.

3. Go to the Clip screen on the VGA, all banks of remote system are now

displayed.

4. Select the clip to name.

5. Type the desired name on the keyboard.

6. Press F1 to name the remote clip.

→ In CAM mode, only the camera where the cursor is located is named

→ In CLIP mode, all cameras of the clip where the cursor is located are
named.

Note

To be able to rename a clip on a remote server, the Clip Edit by
Network
parameter must be enabled in the Setup menu.

14.7.3

H

OW TO

M

ODIFY

IN/O

UT

P

OINTS OF A

R

EMOTE

C

LIP

1. Recall the desired clip.

2. Browse inside the clip until you reach the desired frame.

3. Press IN / OUT to mark a new Short IN / Short OUT points.

Note

To be able to trim a clip on a remote server, the Clip Edit by
Network
parameter must be enabled in the Setup menu of the
remote machine.

14.7.4

H

OW TO

I

NSERT

R

EMOTE

C

LIPS

I

NTO A

P

LAYLIST

1. Select the Remote LSM via the Network menu.

2. Select a remote clip in the banks. The corresponding F_ key lights red.

3. Press ENTER on the Remote.

4. Repeat the 3 first steps as necessary until last clip is entered.