beautypg.com

Rst cam, Sync to, Toggle / all – EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual

Page 82: 2nd ctrl, Ctrl

background image

EVS

Multicam - User Manual

EVS Broadcast Equipment SA – March 2008

Version 9.00

73

R

ST

C

AM

This function restores the position of cameras on the active channels: CAM
A on PGM1, CAM B on PGM2,…

Note

When a clip/playlist is loaded on a channel, switching back to Live
mode will recall the record train, which was last used on that
output. This avoids too frequent uses of the Rst Cam function.

S

YNC

T

O

This button allows you to synchronize the selected PGM in use with another
one. Press this button and then select the PGM to be used as a reference.
This function is not available with network trains.

T

OGGLE

/

A

LL

The Toggle function is only available in 3PGM mode:

Toggle OFF: Selecting an output channel results in controlling that

channel and disables the control on others.

Toggle ON: Selecting a channel will alternatively enable/disable the

control over that channel without changing the control on the others.

All: This enables the control on all channels.

2

ND

CTRL

This function allows the operator to swap the control of one or several play
channels between the EVS remote and a third-party controller using the
Sony BVW75 or XtenDD35 protocol. Both controllers receive permanently
the status of the channel(s), but only one controller at a time is able to
actually control a channel. The secondary controllers are defined in Section
7 of the remote Setup Menu.

Press this function to enter the 2nd CTRL menu, select the channels that