EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 66)

EVS Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
57
When the current picture on the primary channel is neither a clip nor a cue
point, or if the operator is in Playlist mode, pressing the BROWSE key
allows him to browse inside the clips of the current playlist by turning the
jog dial.
INSERT
This function inserts a clip before or after (depending on the Setup menu)
the current position inside the playlist.
ENTER
This function appends clip(s) at the end of the current playlist. This is also
used to confirm saving of clips, and validate various options and messages.
MENU
This function allows the operator to gain access to the secondary menu.
SHIFT+MENU on the Remote gains access to the Main menu.
Also used as an ESCAPE key to cancel some options and messages.
CLEAR
This function clears the IN / OUT/ playlist / CLIPS / CUE points.
Note
• To clear one CUE point, recall the desired cue point and press
CLEAR + MARK key.
• To clear all cues: when current picture is not a CUE point,
press CLEAR + MARK key. A message appears to confirm the
command.
R
EBOOTING THE
S
YSTEM FROM THE
EVS R
EMOTE PANEL
«Hard Reboot»
In the event that the system needs to be rebooted, the process can be
accomplished from the Remote panel. Keep in mind that doing this while
Multicam is running will of course force the Multicam application to close
abruptly, and up to 1 minute of the material being recorded and not clipped
could be lost.