EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 83)

EVS Multicam - User Manual Version 9.00
EVS Broadcast Equipment SA – March 2008
74
you want to pass to the secondary controller by pressing the corresponding
A, B or C key, then press D (DONE) to validate your selection. Do the same
to bring the control of a channel back to the EVS remote.
S
ELECTING A CAMERA ON A CHANNEL
This function makes it possible to select first the channel where you want to
change the current camera. You can notice that the TAKE key at the bottom
of the remote lights red. If you press the TAKE key now, it lights green and
the menu on the LCD display changes to let you select the desired camera.
To return to the PGM selection menu, press the TAKE key again.
Note
The 1PGM mode is a simplified version of the 2 or 3PGM modes.
The operational menu has less functions:
Local 2nd CTRL
Cam A Cam B Cam C Cam D
Also, the user does not need to select a channel to enable or
disable the secondary controller. Since there is only 1 channel
available in this mode, the operator just has to press SHIFT + D to
swap the control between the secondary controller and the EVS
remote.
P
LAYLIST
C
ONDITIONAL
M
ODE
This mode is only available in 2PGM and 3PGM modes. It allows the
operator to load and control several playlists simultaneously from the same
Remote panel, or to load a playlist on one channel while performing other
operations on the other channel(s). To use this mode, the “Load Playlist”
parameter of the setup menu must be set to “Conditional” (p.4.2 F5).
To use this mode, select one channel (for example PGM1), and press the
PLST key once, twice or three times to enter the PLST EDIT or the PLST
DIFF mode (refer to the “Playlist Management” Section of this manual for
details about these modes). You can notice that the TAKE key button lights
green. Pressing the TAKE key will allow the operator to return to the PGM
selection menu, and select another PGM channel where he can start a
replay, load a clip or another playlist, etc.
In this mode, if the operator selects a PGM channel where a playlist is
loaded and presses the TAKE key, he will enter again the PLST EDIT or
PLST DIFF mode.
When playlists are loaded on all channels currently controlled by the
operator in MULTI PGM mode, the TAKE key lights red. If the TAKE key is
pressed, the remote will enter a specific PLST DIFF mode, where the
operator can control several playlists simultaneously, and browse them or
roll them in sync. NEXT and SKIP functions are also available and will apply
on all controlled playlists. The TAKE button will not light red if one of the
controlled channel does not contain a playlist.