EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 19

EVS
Multicam - User Manual
Version 9.00
EVS Broadcast Equipment SA – March 2008
10
Function Key
Use
configurations:
• 2 play channels for each remote:
In this configuration, each Remote panel can select
PGM+PRV or 2PGM mode. Each Remote panel can
manage video transitions (cut, dissolve, wipe) in
PGM+PRV and playlist modes.
• 3 play channels for the 1
s t
remote and 1 play
channel for the second remote.
In this configuration, the 1
s t
remote can select
PGM+PRV or 3PGM mode and can manage video
transitions. The 2
n d
remote is forced to 1PGM
mode and can only handle cut transitions.
F3: 3 Remotes
Three Remote panels are used in the configuration.
F4: 4 Remotes
Four Remote panels are used in the configuration.
F5: Char. On/Off
Enables or disables the on-screen display (Time code,
Clip ID,…) on the output monitors.
F6: Exit
Exits the Multicam software and returns to the EVS
Menu.
F7: Clear all
clips
Clears all clips. All clips will be lost. A confirmation of
this command is required.
For more information to this action, refer to the section
11.2.12 “How to Clear all Non Protected Clips”, on
page 92.
Note: This command is not similar to the Clear Video
Disks from the Maintenance menu. If you wish to
refresh completely the server, i.e. to clear all clips
including the protected ones, you need to use Clear
Video Disks rather than Clear all clips.
F8: Stop Record
Stops the record. The REC key will go off and the F8
function key is now used to restart the record.
F9: Fill Playlist
«Dump» feature which allows all clips to be «dumped»
at the end of the current playlist. This allows the
operator to save all material to tape, as a backup
feature after a show is complete. You can select in the
Setup menu which camera angles have to be included
in the Fill Play-List function.
If your clips are currently connected to another XT[2]
server on the network, the clips from that server will
be added to your current playlist.
Make sure the playlist you have selected is an empty
one. This function will append the clips at the end of
an existing playlist.
Important
In order to guarantee the validity of data and clips previously
saved, it is advised to properly exit the application by pressing
ALT+ Q and ENTER from the keyboard, or F6 and then ENTER from
the Remote panel. DO NOT TURN OFF THE SYSTEM WHILE THE
APPLICATION IS RUNNING.