EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 87)

EVS Multicam - User Manual Version 9.00
EVS Broadcast Equipment SA – March 2008
78
11. Clip Management
11.1 INTRODUCTION
11.1.1 C
LIP
S
TRUCTURE
A clip is defined by Short IN and Short OUT points. When referring to Short
IN and Short OUT points, the operators usually use the terms IN point and
OUT point.
When Short IN and Short OUT points are set, the system automatically write
protects a user definable length of material before and after the Short
IN/OUT points respectively, these are referred to as the guardbands.
For this reason, the IN point before the guardbands and the OUT point after
the guardband are called Protect IN point and Protect OUT point.
It is possible to trim a clip by redefining Short IN and Short OUT points.
If Short IN and Short OUT points are defined, only the fields between those
two points will be played if the sequence is recalled (the same applies when
the sequence is included in a playlist).
Fields between Protect IN and Short IN and fields between Short OUT and
Protect OUT (guardbands) can be reached with the jog. So the Short IN
and Short OUT points can be redefined.