Siemens Sinumerik 810T User Manual

Page 95

09.91

2 Operation

2.5 Glossary of softkey functions

SERVICE AXES

In this display, all the axis service data are displayed.
With the ”Page” key you can switch to the desired axis.

SERVICE DRIVE

All data required for servicing the integrated drive control (IAR) are shown in the display obtain-
ed by pressing this softkey.

However the hardware for the IAR is not implemented on the GA3, SW2.

SERVICE SPINDLE

All data required for servicing the spindles are shown in the display obtained by pressing this
softkey. You can switch to the spindle required with the “page down” key.

SETTING DATA

Using setting data, the operator (user) fixes certain operating states. Setting data are adjust-
able for:

– Programmable and settable zero offsets
– External zero offsets
– R parameters
– Spindle data
– Axial data
– Angle of rotation
– Scale modification
– Data transfer
– General data (setting data bits).

SIMULATION

To test the program the programmed movements are shown on the CRT display. Programming
errors are displayed as alarms.

SINGLE BLOCK

After ”Program start” only one block is processed. The next block is only processed after
another operation of ”Program Start”.

SKIP YES-NO

With ”YES” selected, the blocks marked with an oblique (/) are skipped
during program processing (Program control).

SPECIAL BLOCK

You select G04, G92, M19, G58, G59, G50 and G51 with this softkey.

SPECIAL FUNCT.

The special functions M00, M01. (1st M Group) and M 36, M37 (4th M Group) are grouped
together in this function.

2-71

SINUMERIK 810T, GA3 (BN)