Siemens Sinumerik 810T - Manual (Page 258)

4 Monitoring Functions 09.91
4.6 Listing of the alarms/alarm description
Alarm No.
Alarm Text:
2039
”Reference point not reached”
Reason:
Effect:
Remedy:
Explanation:
Attention:
The reference point has not been traversed to in all defined axes
Inhibiting of NC START
Traverse the related axes to reference point
The need to traverse to reference point can be suppressed for one or
more special axes with axis-specific machine data.
Software limits are not active for these axes.
Alarm No.
Alarm Text:
2040
”Block not in memory”
Reason:
Effect:
– During block search, the required block number was not found.
– During a jump in the program, the required block number could not
be found in the given direction
Inhibiting of NC START
Alarm No.
Alarm Text:
2041
”Program not in memory”
Reason:
Effect:
– The pre-selected program is not in the memory
– The subroutine called is not in the memory
Inhibiting of NC START
Alarm No.
Alarm Text:
2042
”Parity error in memory”
Reason:
Effect:
Remedy:
One or more characters in the memory have been deleted and can no
longer be identified (these characters are output as ”?”)
Inhibiting of NC START
– Correct the program in EDITOR or delete the complete block and
reenter it
– When a lot of ”?” are shown, it is possible that the entire memory
has been deleted; in this case, check the battery.
Alarm No.
Alarm Text:
2043
”Programming error on transformation”
Reason:
Effect:
Remedy:
– Programming of real axes of the transformation grouping whole
transformation is selected.
– Programming of fictitious axes while transformation is not selected.
– Repeated selection of transformation without having deselected the
current transformation.
– Programming of traverse movements in the selection block.
NC START inhibited.
Press the “RESET” key.
4-16 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)