Siemens Sinumerik 810T - Manual (Page 266)

01.93 4 Monitoring Functions
4.6 Listing of the alarms/alarm description
Alarm No.
Alarm Text:
2184
”M fnct. for C axis invalid”
Alarm No.
Alarm Text:
2189
”Transformation undefined”
Reason:
Remedy:
– Type of transformation not defined.
– Option bit for the transformation not set.
– Transformation axes defined multiply or incorrectly.
Press the “RESET” key.
Alarm No.
Alarm Text:
2190
”Transformation axes assigned””
Explanation: When transformation is selected, one of the real axes of the
transformation grouping is programmed in another channel (except
channel 1).
Alarm No.
Alarm Text:
2191
”Transformation in zero”
Reason:
Remedy:
A real axis (usually the X axis) is in the zero on selection of transform-
ation (G131).
Press the “RESET” key.
Alarm No.
Alarm Text:
2192
”Axis doubling (duplication) active”
Reason:
Effect:
Remedy:
– PLC signals QB 81.2 or QB 81.3 have changed outside the “Reset
state”.
– Traverse key pressed in “JOG mode” in “AUTOMATIC active”
state, while PLC signal QB 81.2 or QB 81.3 was active and
MD 5019.0 set.
– While axis duplication is active, the axial PLC signals (servo enable,
feedrate enable, mirror, follow-up, axis disable) are not the same for
both axes.
– PLC signals QB 81.2 and QB 81.3 at ”Zero” while option bits is set.
NC START inihibited.
Set PLC signals correctly.
Alarm No.
Alarm Text:
2193
”No additional axes possible”
Reason:
Remedy:
Only appears when a block search with calculation is initiated in the
target block and MD "Additional axis after block search with
calculation" is set, if
1. additional axes are to be programmed in G36 blocks,
2. additional axes are to be programmed in G98 blocks which
have no axes.
For 1. Block search with calculation to program block without G36
function.
For 2. Block search with calculation to program block without G98
function.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-23
SINUMERIK 810T, GA3 (BN)