Siemens Sinumerik 810T - Manual (Page 132)

09.91 3 Operating Sequences
3.1.6 Setting data: ”R PARAMETERS”, ”SPINDLE”, ”AXIAL”, ”ANGLE OF ROTATION”, ”SCALE MODIFICAT.”
To do this enter the axis name, e.g. “X”, and
assign the number of the handwheel, e.g.
“1”, to it.
X
7 =
H
1
F
You can also assign several axes to a handwheel, but you can only ever enable one axis for
this handwheel (for further details, see “HANDWHEEL” in Section 3.2.9 for “DRF” in
Section 3.2.10).
Press the softkey “WORKING AREA LIM” to return to the display for the minimum and
maximum working area limitation.
Operate the ”SETTING DATA” softkey in any
operating mode.
Operate the ”ROTAT. ANGLE” softkey.
Extend the softkey menu displayed using the ETC
key to the right below the display.
”ANGLE OF ROTATION” setting data
ROTAT.
ANGLE
SETTING
DATA
Sequence of operation for ”ANGLE OF ROTATION” setting data
The SETTING DATA COORDINATE ROTATION input screen form appears in the
“AUTOMATIC” mode.
Enter the desired angle of rotation A... for G54 to G57 in this screen form (the angles of
rotation A... for G58 and G59 are defaulted by the program and only displayed in the screen
form).
Then proceed as follows:
With the cursor keys, position the cursor at the
desired input field (G54 ... G57).
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-31
SINUMERIK 810T, GA3 (BN)