4 editing and input keys – Siemens Sinumerik 810T User Manual

Page 26

2 Operation

11.90

2.1.1 SINUMERIK 810T operator interface with integrated machine control panel

2.1.1.4 Editing and input keys

View of editing and input keys

With this key you delete:
•

Characters on the input line (see Section 2.1.1.1)
–

with single operation:
always the last / most extreme right character

–

with continuous operation:
all characters consecutively, from right to left, until the input line is
clear.

•

Characters on the operator message line (see Section 2.1.1.1)
–

with single operation:
all characters simultaneously.

Delete input / operator message

Delete word / block

With this key you delete from the part program memory
•

The word on the CRT display to the right of the cursor (see Section
2.1.1.5), when the same address is shown on the input line (see
Section 2.1.1.1)

•

The block on the CRT display to the right of the cursor, when the
same block number is shown on the input line.

Modify word

With this key you modify the word on the CRT display to the right of the
cursor in the part program memory (see Section 2.1.1.5):
The word marked with the cursor is modified to the word with the same
address that is shown on the input line (see Section 2.1.1.1).

You conclude your inputs with this key:
•

The characters shown on the input line (see Section 2.1.1.1) are
transferred into the screen list, the input fields where the cursor (see
Section 2.1.1.5) is positioned.

•

A word shown on the input line is transferred into the part program
memory.

Input character / word

2-10

SINUMERIK 810T, GA3 (BN)