9 ”selecting a program – Siemens Sinumerik 810T User Manual

Page 169

3 Operating Sequences

11.90

3.1.13 Program management

3.1.13.9 ”Selecting a program”

Using ”SELECT PROGRAM”, you can either start a new program, or call a program already
stored in the program memory, e.g. for editing (3.1.12) or simulation (3.1.14) .

Operate the ”PART PROGRAM” softkey in any of the
operating modes:
PRESET / JOG / AUTOMATIC /
INC FEED 1 .... INC FEED 10 000 / REFPOINT.

Operate the ”EDIT” softkey.

Using the keyboard, enter the desired program number
”%...” (or ”L...”) ”% 5” in this example.

Operate the ”SELECT PROGRAM” softkey.

The program number called is shown on the CRT and, if there is a program with this
number already in the memory, the start of the program and blocks N0005 to N ... .

Using the ”Page up/down” keys, you can
call up the parts of the program not yet displayed (if
already in memory) onto the CRT.

PART
PROGRAM

EDIT

SELECT
PROGRAM

5
J

Sequence of operation

3-66

SINUMERIK 810T, GA3 (BN)