4 interrupting the program – Siemens Sinumerik 810T User Manual

Page 208

3 Operating Sequences

01.93

3.2.3 Influencing ”AUTOMATIC” operation

3.2.3.4

Interrupting the program

Sequence of operation

Now operate the ”NC Start” and ”Feed start” keys.
The feed is enabled again.

Operate the ”NC STOP” key.
The feed drives are brought to a controlled standstill
without leaving the programmed path.

The “STOP: AUTO INTERRUPTED” display appears.

You can interrupt a running program in one of the following ways:

1) Perform one of the operating mode changes which causes a reset (see Section

2.3.4). The drives are brought to a controlled standstill.

2) By NC STOP:

The axis positions programmed in the current block are

approached with linear interpolation.

Caution: danger of collision!!

3-104

SINUMERIK 810T, GA3 (BN)