Siemens Sinumerik 810T User Manual

Page 33

11.90

2 Operation

2.1.1 SINUMERIK 810T operator interface

with integrated machine control panel

This key enables you to run a part program on a block-by-block basis in
the ”AUTOMATIC ” operating mode.
When you operate this key, the ”SBL” (Single block) message is dis-
played on the first line of the CRT (Section 2.1.1.1).

The current part program block is processed when

you press the ”Program start” key:

When the block has been processed, the message”HOLD SINGLE
BLOCK” is displayed on the CRT.
When you operate the ”Program start” key again, the
next block is called and processed etc.

You terminate single block operation by pressing the

key

again.

Single block

Program stop / Program start (NC stop / NC start)

When you press the ”Program stop” key:

The operation of the part program is interrupted.
You can continue the operation by pressing ”Program start”.

When you press the ”Program start” key:

The active part program is re-started at the current block. In
Automatic operation, the overstored functions are transferred to the
PLC.

Spindle stop / Spindle start

When you operate the ”Spindle stop” key:

•

the spindle speed is reduced to standstill.

2-17

SINUMERIK 810T, GA3 (BN)