Siemens Sinumerik 810T - Manual (Page 183)

3 Operating Sequences 11.90
3.1.15 Data input/data output
3.1.15.2 Data input
Operate the ”DATA IN-OUT” softkey in any of the
operation modes:
PRESET / JOG / AUTOMATIC /
INC 1 .... INC 10 000 / REFPOINT.
DATA
IN-OUT
Sequence of operation
This input form is shown, with the input
field for ”Interface for data in” marked
in inverse video.
(( 810T))
(( Bild 37 von Druckerei
einmontieren
or
Select the softkey function ”DATA-IN START”
By doing this you enable the control's receive function.
Now enter:
”1” ( for input into interface 1 ) or
”2” ( for input into interface 2 )
and store it with the input key.
DATA-IN
START
1
F
2
D
On the upper right-hand side of the CRT the message DIO (Data input/output) is
displayed.
On the Data type: line the data coming from the transmission device (tape reader,
programmer ...) is identified.
The following table explains the types of data that can be loaded into the 810T:
3-80 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)