Siemens Sinumerik 810T User Manual

Page 115

Text mode
Original mode

3 Operating Sequences

09.91

3.1.4 Tool offset

TOOL
DATA

Press the “TOOL DATA” softkey.

The data stored in the magazine table (PLC) is displayed (the location No. is the same as the
D No. of the tool offset table). Press the “RECALL” key to return to the “TOOL OFFSET”
menu.

LIST OF
TOOLS

Press the “LIST OF TOOLS” softkey.

This display then appears on the
screen.

((Bild 810T/59 einmontieren))

NEXT

When you have pressed the “NEXT” softkey further
stored tool numbers are displayed. You cannot “PAGE
UP” in the tool table.

DISPLAY DATA

Press the “DISPLAY DATA” softkey.
The first six tool numbers stored (T number) in
accending order of location numbers.

Press the “GEOMETRY DATA” softkey to move to the “TOOL OFFSET” menu. You can
return to the standard menu by pressing the “RECALL” key twice.

3-16

SINUMERIK 810T, GA3 (BN)