5 program sequencing (ops) – Siemens Sinumerik 810T User Manual
Page 209
09.91
3 Operating Sequences
3.2.3 Influencing ”AUTOMATIC” operation
3.2.3.5
Program sequencing (OPS)
The "Program sequencing" function is an ordering data
option.
This function enables you to automatically retroload and execute programs from a diskette
following a predefined list. To do this you need the PLC function block FB120 and a DSG-2S
disk drive. Each must be ordered separately.
You can monitor the execution of the program sequencing in a separate screen display and - if
desired - interrupt it.
After the interruption you can restart the program at any point within the list.
AUTOMATIC
You are in the AUTOMATIC mode.
Having expanded the softkey menu you operate the "OPS" softkey.
OPS
Sequence of operation
This display appears on the screen.
(( 810T))
(( Bild 49 von Druckerei
einmontieren
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
3-105
SINUMERIK 810T, GA3 (BN)