10 program input, 1 program input with the keyboard – Siemens Sinumerik 810T User Manual

Page 143

3 Operating Sequences

11.90

3.1.10 Program input

3.1.10 Program input

You can input a program

•

using the keyboard

•

using operator guidance (prompting).

While entering a program using one of the above methods, it is possible to change over to the
other method; you can alternate between working with operator prompting and the keyboard.

3.1.10.1 Program input with the keyboard

You enter an opened program %... with the individual blocks N...LF to N...LF character by
character only with the keyboard.

Call any of the following operating modes:

•

PRESET (Actual value setting)

•

JOG (Feed/jog)

•

AUTOMATIC (Automatic operation)

•

INC 1 ... INC 10 000 (Incremental jog)

•

REFPOINT (Traverse to reference point)

Now operate the ”PART PROGRAM” softkey.

PART
PROGRAM

For this purpose, use the operating mode selection key, and subsequently the relevant
softkey (see below) or the operating mode selector switch (external machine control panel).

and

Sequence of operation

Apart from program input, the PART PROGRAM function also serves for:

– Program editing (see Section 3.1.12)
– Program management (see Section 3.1.13)
– Program simulation (see Section 3.1.14).

3-42

SINUMERIK 810T, GA3 (BN)