Siemens Sinumerik 810T - Manual (Page 178)

09.91 3 Operating Sequences
3.1.14 “SIMULATION”
Operate the ”SELECT PROGRAM” and ”SIMULATION”
softkeys one after the other.
Using the numerical keyboard, enter the desired
program number ”% ...” (or ”L...”)- ”% 16” in the
example.
Using the ETC key, extend the displayed softkey menu.
When you operate the ”PROGRAM CONTROL”
softkey...
The new softkey menu shows two possible selections described below under a) and b):
BLOCK
SEARCH
PROG.
CONTROL
a) b)
a) “PROGRAM CONTROL”
SELECT
PROGRAM
%
1
F
6
K
SIMULA-
TION
PROGRAM
CONTROL
... the relevant CRT display is shown.
You can alter the simulation ”Status”
using a softkey, by selecting the
desired function and setting to ”YES”.
((Bild 810T/33 einmontieren))
SIMULA-
TION
Now operate the ”SIMULATION” softkey again, and then
operate the ETC key to extend the displayed softkey
menu.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-75
SINUMERIK 810T, GA3 (BN)