Siemens Sinumerik 810T - Manual (Page 150)

11.90 3 Operating Sequences
3.1.10 Program input
Using the numerical keys, you enter
the desired ”X” coordinate,
with the value ”25”, and store
it with the input key.
”X25” is displayed.
..
.
etc.
..
.
etc.
Complete the block by operating the
”BLOCK END” softkey.
”L
F
” is displayed.
The complete block is transferred into
the program memory.
BLOCK
END
Operate the ”BLOCK NUMBER” softkey.
The control generates the next number, ”5”
higher.
”N0010” is displayed and created in the program.
Continue with input until you have completed the part program.
X
7 2
D
5
J
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-49
SINUMERIK 810T, GA3 (BN)