Siemens Sinumerik 810T - Manual (Page 139)

3 Operating Sequences 09.91
3.1.9 TRANSMIT coordinate transformation
State / event matrix for transformation selection and deselection:
Note 1)
Case 1: Transformation deselection on RESET: RESET is caused by pressing the RESET key, part programm
(PP) end and mode change except REFPOINT.
Case 2: No transformation deselection on RESET: generally transformation modal except for REFPOINT.
Ereignis
Automatic
passive
Automatic
active
JOG
JOG
(Automatic
interrupted)
Automatic
interrupted
NC Start Automatic
active
Automatik
active
NC Stop Automatic
interrupted
Change to
JOG
JOG JOG
(Automatic
interrupted)
JOG
(Automatic
interrupted)
Change to
AUTOMATIC
Automatic
passive
Automatic
interrupted
RESET Automatic
passive
1) Deselec-
tion of
transform.
Automatic
passive
1) Deselec-
tion of
transform.
JOG
1) Deselec-
tion of
transform.
JOG
1) Deselec-
tion of
transform.
Automatic
passive
1) Deselec-
tion of
transform.
Change to
REFPOINT Deselection
of transform.
Deselection
of transform.
Deselection
of transform.
Deselection
of transform.
Deselection
of transform.
State
Event
Explanations of the state/event matrix:
The fields within the matrix contain the state subsequent to the event and information on the
transformation state.
– “AUTOMATIC passive” state:
No program is being executed (Reset).
– “AUTOMATIC active” state:
The program is being executed (program running).
– “JOG” state:
You can traverse manually in the mode “JOG”, “INC” or “REPOS”.
– “JOG” (AUTOMATIC interrupted) state:
The program was interrupted and the “JOG” state selected.
– “AUTOMATIC interrupted” state:
The programm was interrupted, without leaving the “AUTOMATIC” mode (NC Stop).
3-38 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)