Siemens Sinumerik 810T - Manual (Page 288)

01.93 7 Interfacing to the Machine
7.1 General
7 Interfacing to the Machine
7.1 General
The operating of the SINUMERIK 810T depends on the setting of the machine data, and the
Options.
In the basic version of the SINUMERIK 810T (Order no. 6FC3 251-1AC), the standard
machine data are set in the works.
It can be modified when interfacing to the machine and when the control is equipped with
Options.
These Sections 7.2 and 7.3 contain tables showing:
• possible Order Options which influence the operation.
• all of the standard machine data which can be modified by machine tool manufacturer,
and influence the operation.
The tables have extra columns for entering the configuration of the control as delivered.
7.2 Ordering data - Options
The Order No. for the basic version of the SINUMERIK 810T control is 6FC3 251 - 1AC
If the control is equipped with options, the Order No. is extended.
It then has the following format:
e. g. 6FC3 251 - 1AC - Z
B03 + B75 +..
indicates that Order Code(s)
follow(s) two Order Codes
Tick the boxes in the ”Option supplied with control?” column for the following table if
the Order No. 6FC3 251-1AC-Z is followed by the order code listed.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 7-1
SINUMERIK 810T, GA3 (BN)