Siemens Sinumerik 810T User Manual
Page 113
3 Operating Sequences
09.91
3.1.4 Tool offset
This display then appears on the
screen.
((Bild 810T/58 einmontieren))
Enter data for up to four tools in this input screen form.
ENTER
Now press the“ENTER” softkey.
The data input is transferred to the PLC and stored in the magazine table (visible on the
screen).
PAGE
DOWN
PAGE
UP
Press the “PAGE UP” or “PAGE DOWN” softkeys to
page through the magazine table.
GEOM.
DATA
Press the “GEOMETRY DATA” softkey.
The input form for tool offset data is displayed again.
3-14
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)